juni0r
1 subscriber

juni0r
Send Message

Description

TOYOTA CAMRY LE / SE / XLE
DUAL SEAT HEATER KIT
STOP: Damage to the vehicle may occur. Do not proceed until process has been complied with.
OPERATOR SAFETY: Use caution to avoid risk of injury
CRITICAL PROCESS: Proceed with caution to ensure a quality installation.
GENERAL PROCESS: This highlights specific processes to ensure a quality installation.
TOOLS & EQUIPMENT: This calls out the specific tools and equipment required for this process
VEHICLE PROTECTION: This calls out for protection of vehicle required for this process Conflicts
DUAL SEAT HEATER KIT
Section II –Installation
Pre-Installation Suggestions
1. Disconnect the negative battery cable and wait for 3 minutes before beginning installation, to avoid unintended air bag deployment. Note and record any anti-theft radio codes prior to disconnecting. Figure 1
Figure 1
2. If vehicle is in Electronics work area, proceed to step 1 page 4. If vehicle is in Leather shop, proceed to next section “Install Heating Elements”.
Install Heating Elements
1. Remove seats from vehicle per vehicle’s service manual and place on a clean work surface.
2. Remove seat covers per vehicle’s service manual.
3. Caution: The heating elements must be installed wrinkle-free.
4. Obtain the back heating element. Remove the protective layer from the element’s double sided tape and place it onto the seat back foam roughly centered on the foam from side to side with the top of the element just below the
transverse listing (tie bar trench). Figure 2
5. Route the element wiring harness down to the bottom of the seat back, inboard of the hinge cover and under the seat.
Note: Factory leather and cloth
6. Repeat the process above for the seat cushion,
laying the heating element transversely such
that it does not interfere with the horizontal
listings. Figure 3
7. Secure the seat harnesses to the tie down bar
and run down the side listing to the back of
the seat, then down. Re-attach seat covers.
Figures 4-5
8. Replace the driver and passenger seats into the
vehicle. Connect the seat element connectors
to the main harnesses. Secure the harness
with wire ties and allow adequate slack to
prevent damage during seat adjustment.
TOYOTA CAMRY LE / SE / XLE
DUAL SEAT HEATER KIT
Section II –Installation
Install Heating Elements (cont’d)
9. Make sure vehicle floor-pan is clear and
carefully re-locate seat into vehicle.
10. Ensure all connectors under seat have been
properly connected and secured with wire ties,
and that nothing will be damaged upon seat
movement.
11. Install seat bolts and torque per service
manual.
12. Reconnect battery cable(s). Torque 10mm bolt
to 48 inch-pounds. Re-enter any theft
deterrent information, if applicable...

Share

Tags

Toyota camry , Automotive

Meta Information

  • Author : rdean
  • Generator : Acrobat Distiller 8.1.0 (Windows)
  • Created : Thu Sep 20 14:51:00 2012
  • Last Modified : 27th of October 2014 07:58:42 PM
  • Total Pages : 7

Share

Report