Found 9515 related files. Current in page 1
Interference Between Clutch Damper and Flywheel Bolts On 2003-2006 Caterpillar 3406E C-15 & C-16 Diesel Engines The AERA Technical Committee offers the following information regarding possible interference between the clutch damper and flywheel bolts on 2003-2006 Caterpillar 3406E, C-15 and C-16 diesel engines. Engines built or serviced with the VCT plus clutch damper, introduced in April 2003, have the possibility of the clutch damper interfering with the flywheel mounting bolts. This applies to the following clutch part numbers: 108009-32Y, 108925-20, 108925-25, 108926-20Y, 108926-25Y, 109701-20, 109701-25, 109705-20Y, 109705-25Y & 109706-32Y. Correction/Action: Any repair that has required the transmission to be removed from the truck, and the engine serial number is 5EK1 and up, 6TS1 and up, 1LW1 and up, 2WS1 and up, 6NZ1-92122, 7CZ1-04382, MBN1-21447, BXS1-00984, 5DS1 and up, or 1MM1 and up, requires checking the flywheel bolt washers. You must verify the 5mm washer has been replaced with the 3mm washer, Caterpillar Part Number 8D-5054. Failure to replace the washers could result in damper rivet interference. Torque the bolts to 270 Nm +/- 40 Nm (200 ft/lb +/- 30 ft/lb). It is also suggested that paint may be applied to bolt heads to show verification and completion identification.
Additional service information is available in the Detroit Diesel Series 60 Service Manual, 6SE483. The next revision to this manual will include the revised information. As a convenience to holders of the Series 60 Service Manual, information in service manual format is attached. The page(s) may be inserted into the manual. NOTE: Manual insert pages are numbered for insertion into the current Series 60 Service Manual dated January 2004. Service manuals are available from authorized Detroit Diesel distributors. If this bulletin was obtained from the Internet, service manual page(s) are available by returning to the screen “SIB Index”, selecting attachment pages, and printing the page(s). Detroit Diesel®, DDC®, Series 60® and the spinning arrows design are registered trademarks of Detroit Diesel Corporation. © Copyright 2004 Detroit Diesel Corporation. All rights reserved. Printed in U.S.A.
New flanged multi-point socket head bolts have been released to prevent the MBE 900 pilot bearing from walking out of the flywheel housing. The new bolts will replace two flywheel bolts, located 180 degrees from one another. KIT CONTENTS The MBE 900 Pilot Bearing Bolt Service Kit P/N: A9269900105, consists of the following parts, listed in Table 1: Part No. A9269900005 18SP666 Table 1 Qty. 2 1 Description Flanged Multi-point Socket Head Bolts Installation Instructions MBE 900 Pilot Bearing Retaining Bolt Service Kit (P/N: A9269900105) INSTALLATION PROCEDURE Use the following procedure to install the new flanged multi-point socket bolts: 1. Shut off engine and apply the parking brake, chock the wheels, disconnect vehicle battery power, and perform any other applicable safety steps. 2. Remove the transmission. 3. Remove clutch from flywheel. 4. Pull the crankshaft position sensor out of the flywheel housing about 8 mm (0.32 in.). 5. Remove the end cover from the flywheel housing and install the engine barring tool (J-46392). Tighten the bolts on the barring device to 25 N·m (18 lb·ft). Insert the locking pin to block the device and prevent it from rotating. 6. Using J-46385, the flywheel and main pulley socket tool, remove two flywheel multi-point socket head bolts from the flywheel, 180 degrees apart. See Figure 1.
The major cause of clutch failure is excessive heat. Excessive heat generated between the flywheel, driven discs, intermediate plate and pressure plate can cause the metal to flow and the material to be destroyed. If this occurs, the clutch can burst which can cause property damage, serious bodily injury or death. In order to prevent clutch failure resulting from excessive heat: 1. Do not exceed recommended vehicle loads. 2. The clutch should only be used for the recommended applications. 3. Drivers should be properly trained in starting, shifting and operation of the clutch. 4. Drivers should report erratic clutch operation as soon as possible to permit maintenance personnel to inspect, adjust or lubricate as required. 5. The removal and installation procedure described for each component may vary for your vehicle. For Solo and Heavy-Duty ECA clutches only, install shipping bolts before removing clutch assembly from the flywheel. IMPORTANT For service information and assistance, call the Roadranger Help Desk at 1-800-826-HELP (4357) (Mexico: 01-800-826HELP (4357). You may also find more information about Eaton Clutches at www.Roadranger.com. Mechanics must be familiar with proper clutch adjustment, linkage adjustment, lubrication and other maintenance troubleshooting procedures outlined in the Failure Analysis Guide. Every effort has been made to ensure the accuracy of the information contained in this manual. However, Eaton Corporation makes no warranty, expressed or implied, based on the information provided.
Emergency Department Visits for Chest Pain and Abdominal Pain: United States, 1999–2008 Farida A. Bhuiya, M.P.H.; Stephen R. Pitts, M.D., M.P.H., F.A.C.E.P.; and Linda F. McCaig, M.P.H., Division of Health Care Statistics Key findings Data from the National Hospital Ambulatory Medical Care Survey: 1999–2008 • The number of noninjury emergency department (ED) visits in which abdominal pain was the primary reason for the visit increased 31.8%. • The percentage of ED visits for which chest pain was the primary reason decreased 10.0%. • Use of advanced medical imaging increased strongly for ED visits related to abdominal pain (122.6%) and chest pain (367.6%). Chest and abdominal pain are the most common reasons that persons aged 15 years and over visit the emergency department (ED) (1). Because EDs provide both emergency and nonemergency care (2,3), visits for these symptoms may vary in their acuity. Advanced medical imaging is often ordered to assist in both diagnosing and ruling out serious illness associated with these symptoms (4,5). This report describes trends in visits for chest and abdominal pain in adults and the seriousness of illness and use of imaging in these visits. All data shown are for persons aged 18 and over whose visit was not injury related. Keywords: National Hospital Ambulatory Medical Care Survey • advanced medical imaging • reason for visit Are ED visits for chest or abdominal pain increasing?
Starting mid-2008, Roche introduces a new global packaging design for prescription medicines. This will meet requirements and expectations of health authorities, medical professionals and patients worldwide. The new packaging allows quick and easy identification of the medicine and dosage strength. one product colour specific dosage colour icon of pharmaceutical form dosage colour is repeated How was the design selected? Roche sought feedback from medical professionals and health authorities and reviewed possible design options with more than 700 doctors, pharmacists, nurses and patients worldwide. There was clear support for the selected new design and respondents particularly highlighted that it was easy to recognise. What are the new features? The new packaging design includes d • istinct product and dosage colours for quick identification c • olour banding visible from three sides p • lunger rods and flip-off caps in dosage colours The design is in line with recent regulatory labelling guidelines and industry best practices. There will be no changes in pack dimensions and text. How will the design be implemented? The new packs will be phased in for Roche prescription medicines between mid-2008 and 2010 (approx.). C • ellCept, Copegus, Pegasys and Xeloda will be the first medicines to feature the new packaging design (some country-specific exceptions) T • he remaining medicines will change over the coming months Packs in the old design will not be replaced and can be used until expiry. Please contact your local Roche Office for country-specific details. F. Hoffmann-La Roche Ltd 4070 Basel Switzerland www.roche.com © 2008
Flaunting a healthy manhood makes oral stimulation more inviting, but unappealing male reproductive fluid flavor can be a major turn-off. Dietary changes can have an impact on the sweetness of a man's seed.
http://www.aptranslation.com/ | Multilingual employee handbooks make your international and ESL employees feel like a part of the team and relay important information. Getting the right translation company to translate your policies and procedures into several languages is key to creating an accessible manual.
Setting up Charging the rechargeable battery pack Setting up the rechargeable battery pack 1 Press the tab on the top of the controller’s battery compartment cover, then and pull down to detach the original battery from the controller. Charge your battery pack before its first use and whenever it is drained. 1 Insert the charging plug into the charge port on the front of your wireless controller. 2 Connect the USB plug to any USB port of your Xbox 360. 3 Turn on your console. The charge indicator on the front of the plug glows red as the battery pack charges. When the light glows green, the battery pack is fully charged. Rechargeable battery safety Incorrect battery use may result in battery leakage, overheating, or explosion. When using batteries, make sure that you follow these instructions: • Keep batteries out of reach of children. • Do not heat, open, puncture, mutilate, or dispose of batteries in fire. • If a battery leaks, remove the battery, taking care to keep the leaked fluid from touching your skin or clothes. If fluid from the battery comes into contact with skin or clothes, flush skin with water or remove the clothing immediately. Before inserting a new battery, thoroughly clean the controller with a damp paper towel. • Do not allow metal objects to touch the battery terminals, because they can become hot and cause burns. For example, do not carry the battery in a pocket with keys or coins. • Remove the battery when the product will not be used for an extended period of time.
A very small percentage of people may experience a seizure when exposed to certain visual images, including ﬂashing lights or patterns that may appear in video games. Even people who have no history of seizures or epilepsy may have an undiagnosed condition that can cause these “photosensitive epileptic seizures” while watching video games. These seizures may have a variety of symptoms, including lightheadedness, altered vision, eye or face twitching, jerking or shaking of arms or legs, disorientation, confusion, or momentary loss of awareness. Seizures may also cause loss of consciousness or convulsions that can lead to injury from falling down or striking nearby objects. Immediately stop playing and consult a doctor if you experience any of these symptoms. Parents should watch for or ask their children about the above symptoms— children and teenagers are more likely than adults to experience these seizures. The risk of photosensitive epileptic seizures may be reduced by taking the following precautions: Sit farther from the screen; use a smaller screen; play in a well-lit room; do not play when you are drowsy or fatigued. If you or any of your relatives have a history of seizures or epilepsy, consult a doctor before playing.