Found 1802 related files. Current in page 1
JANE WILLIAMS, PhD, RN Dean and Professor of Nursing School of Nursing, Rhode Island College 600 Mt. Pleasant Avenue, Providence, RI 02908 TEL: 401 456-9608: FAX: 401 456-8206 Email: firstname.lastname@example.org CURRENT EMPLOYMENT Rhode Island College, Dean and Professor of Nursing, School of Nursing, 1975-present; initial appointment as assistant professor, 1975; appointed Professor, 1995, Department Chairperson, 2000, and Dean, 2007. EDUCATION University of Rhode Island, College of Nursing, Kingston, Rhode Island, Ph.D., Nursing, 1995. New York University, School of Education, New York, New York, M.A., Major in Education and Minor in Nursing, 1968; University of Michigan, School of Nursing, Ann Arbor, Michigan, B.S.N. with Distinction, 1966. PUBLICATIONS Williams, J., Brumbaugh, M. & Vares, L., (2006), “Education to improve interdisciplinary practice of health care professionals: A pilot project”, Medicine & Health, Rhode Island, 89 (9), p. 312-313. Mosser, N., Williams, J. & Wood, C. (2006), “The use of progression testing throughout nursing programs: How two colleges promote success on NCLEX-RN”. Annual Review of Nursing Education. Vol.4, p. 305-319. Newman, M. and Williams, J. (2003) "Educating Nurses in Rhode Island: A lot of diversity in a little place", Journal of Cultural Diversity, Vol. 10, No. 3, p. 91-95. Williams, J., (2001) “The Clinical Notebook: Using Student Portfolios to Enhance Teaching and Learning, Journal of Nursing Education. Vol. 40, p. 135-137. Ferszt, G., Massotti, E., Miller, J. & Williams, J. (2000) “Art on Rounds: Research Study of an in-patient oncology unit”, Illness Crisis and Loss. Vol. 8, No. 2, pp. 189-199. Williams, J. (1999) “When Interns Meet Managed Care” [Letter to the Editor]. New York Times, p. 30A. Williams, J., Wood, C., & Cunningham-Warburton, P. (1999) “A Narrative Study of Chemotherapy-Induced Alopecia”. Oncology Nursing Forum. Vol. 26, pp. 1463-1468. Willliams, J. (1999) “Health Policy Tool Kit Helps Students to Get Involved”. ONS Newsletter, 14 (9) p 5.
Safety Recall No. 983 Brake Booster Vacuum Hose Models 2000-2001 (PL) Dodge and Plymouth Neon NOTE: This recall applies only to the above vehicles equipped with a: Ø 2.0L engine (“C” in the 8th VIN Position) built through March 21, 2001 (MDH 0321XX) or a Ø 2.0L High Output engine (“F” in the 8th VIN Position) built through April 11, 2001 (MDH 0411XX). IMPORTANT: Some of the involved vehicles may be in dealer new vehicle inventory. Federal law requires you to stop sale and complete this recall service on these vehicles before retail delivery. Dealers should also consider this requirement to apply to used vehicle inventory and should perform this recall on vehicles in for service. Involved vehicles can be determined by using the DIAL VIP System. Subject The brake booster vacuum hose on about 350,000 of the above vehicles may swell due to oil contamination and become disconnected. A disconnected hose could cause a loss of power brake assist and an increase in engine idle speed. This can increase stopping distance and cause an accident without warning. Repair The brake booster vacuum hose must be replaced. © Copyright 2001, DaimlerChrysler Corporation, All Rights Reserved Safety Recall No. 983 -- Brake Booster Vacuum Hose Page 2 Parts Information Each dealer to whom vehicles in the recall were invoiced (or the current dealer at the same street address) will receive enough Brake Booster Vacuum Hoses to service about 10% of those vehicles. Dealers should determine which brake booster vacuum hose is required for each vehicle at the time appointments are scheduled to assure that the correct part is available when the customer arrives. The vacuum hose for the vehicle to be serviced may be determined by: Ø Using the part code in the third column of the VIN list along with the following table (involved dealers); Ø Using the VIN and part number list electronically transmitted to DIAL System Function 53 (involved dealers); or...
The clutch master cylinder is a device that transforms mechanical force into hydraulic pressure. As the driver presses the clutch pedal, the pedal lever applies force to the clutch master cylinder which transmits hydraulic pressure to the clutch release (slave) cylinder that disconnects engine power to the transmission. Structure and Components [Conventional Type] Inlet Union Oil Spill Hole Aluminum Body Flare Nut Pipe Joint Boot Spring Primary Cup Resin Piston Push Rod Rel Secondary Cup Spring Metallic Clevis Damper Stud Bolt The clutch master cylinder structure consists of the piston, cups, and springs, built within a precision machined body. The primary cup, positioned on the leading side of the body, functions to create hydraulic pressure when fluid is forced inside by the piston. Located on the trailing side is the secondary cup, which guides the piston and prevents fluid from leaking. When the clutch pedal is pressed, the primary cup is blocked away by the piston from the oil spill port leading to the reservoir tank, pressure in the cylinder rises as the fluid is fed through the pipeline. When the clutch pedal is released, the hydraulic pressure and the force of the return spring pulls back the piston to relieve fluid back into the reservoir. The clutch master cylinder is what provides the necessary force to control the application of drivetrain power. 2 Clutch Master Cylinder Variations Clutch Master Cylinder Variations Conventional Port-less Type Stand Alone / Integrated Reservoir Type Types With and Without Stud Bolts Types With and Without Clevis Damper Types With and Without Clutch Booster ...
TABLE OF CONTENTS General Information 2-4 Using the Worldwide Timetable 5 Global Alliance and Airline Partners 6-7 Flight Schedules 8 -143 Train Schedules 144 U.S. Offices 145 - 149 International Offices 150 - 154 Service Highlights New Service Atlanta 1 roundtrip November 1 Palm Springs 1 roundtrip December 1 Jackson Hole 1 roundtrip December 14;Sat/Sun service only 2 roundtrips December 1 St. Thomas 1 roundtrip November 1 Ft. Myers DOMESTIC RESERVATIONS Montego Bay 1 roundtrip November 1 Salt Lake City Jackson Hole Additional Service Atlanta 800-221-1212 Delta Express Additional Service INTERNATIONAL RESERVATIONS Islip From U.S., Puerto Rico, Virgin Islands 800-241-4141 From Canada 800-221-1212 Ft. Lauderdale 1 roundtrip November 1 New York (JFK) 800-511-9629 RESERVATIONS IN JAPANESE 800-327-2850 DELTA EXPRESS 866-2 FLY DLX DELTA SHUTTLE 800-933-5935 DELTA VACATIONS™ 800-872-7786 ARRIVAL/DEPARTURE 800-325-1999 CARGO BOOKING, TRACKING/TRACING 800-DL-CARGO DELTA DASH 800-DL-CARGO SKYMILES INFORMATION 800-323-2323 BAGGAGE 800-325-8224 HEARING AND SPEECH IMPAIRED 800-831-4488 Telephone numbers in this publication are subject to monitoring for quality control purposes. 2 roundtrips November 1 Orlando RESERVAS EN ESPAÑOL Ft. Lauderdale 1 roundtrip November 1 General Information General Information continued DELTA PROGRAMS AND SERVICES SAFETY
RCC Turbos - Stage 1 Turbo Install: Suzuki Hayabusa (Gen 1) • Preparation/Disassembly: Remove the seat. Disconnect negative terminal on the battery. Drain the fuel tank. Remove the fuel tank. Remove the stock fuel pump from the tank. Remove the air box. Remove the MAP sensor and temperature sensor from the air box. Remove left and right side fairings. Drain engine oil. Drain engine coolant. Remove the oil filter Remove the oil restrictor, behind the filter. Remove the oil cooler lines. Remove the radiator and oil cooler, as one unit, leaving only the bracket/support for radiator (before reinstalling the radiator please remove all the tabs along the bottom of the radiator). Remove the entire exhaust system. Remove the PAIR system. Remove the oil pan from the engine. • Sensor Bracket Modification: On the left hand side of bike, on the inside of the frame, you will see a bracket, with a plastic vacuum canister, vacuum control solenoid valve, atmospheric pressure sensor, and some vacuum lines, with a check valve in the vacuum line. Please remove this entire bracket, eliminate all the vacuum lines, the plastic canister, and the control solenoid valve, and also cut off the metal tab that held the vacuum canister. Then reinstall this bracket with only the atmospheric pressure sensor, and plug the wires back in. • Tap/plug PAIR System Holes: Tap the four small PAIR system holes, above the exhaust ports, with an M6 x 1.0 tap. Install the four small M6 screws into the exhaust holes after tapping them. • Modify the Oil Pan: Drill a ¾” hole on the left side of the oil pan. Use thread sealant on the washer, and red Loctite on the threads. Make sure the sealing washer is against the inside of pan, then the stainless flat washer, then the nut. Once the fitting is installed, reinstall the oil pan. • Install Header/Turbo/Oil Lines/Exhaust: Install the header and turbo as a unit, but with the bolts loose. Use four of your original header bolts on the top of the turbo header (Allen head). Use the four new bolts on the bottom row of the header (M8, 10mm flange head). PLEASE NOTE! After installing the dump pipes and waste gate, the nipple on the top of the waste gate remains open, and no hose gets installed on the top fitting. The top fitting is used for boost control on Stage 2 and higher end kits. It is not used on Stage 1 kits.
Functional Resume Sample John W. Smith 2002 Front Range Way Fort Collins, CO 80525 email@example.com Career Summary Four years experience in early childhood development with a diverse background in the care of special needs children and adults. Adult Care Experience Determined work placement for 150 special needs adult clients. Maintained client databases and records. Coordinated client contact with local health care professionals on a monthly basis. Managed 25 volunteer workers. Childcare Experience Coordinated service assignments for 20 part-time counselors and 100 client families. Oversaw daily activity and outing planning for 100 clients. Assisted families of special needs clients with researching financial assistance and healthcare. Assisted teachers with managing daily classroom activities. Oversaw daily and special student activities. Employment History 1999-2002 1997-1999 1996-1997 Counseling Supervisor, The Wesley Center, Little Rock, Arkansas. Client Specialist, Rainbow Special Care Center, Little Rock, Arkansas Teacher’s Assistant, Cowell Elementary, Conway, Arkansas Education University of Arkansas at Little Rock, Little Rock, AR • • • • BS in Early Childhood Development (1999) BA in Elementary Education (1998) GPA (4.0 Scale): Early Childhood Development – 3.8, Elementary Education – 3.5, Overall 3.4. Dean’s List, Chancellor’s List
More than a decade ago, Suzuki developed a machine so unique that it instantly attracted a devoted following around the world. Like its namesake, the Japanese peregrine falcon, Hayabusa is famed for cutting through the air with incredible agility and performance. It combines massive thrust, unmatched maneuverability, and a silky smooth ride on city streets or the open road. Beneath its windswept design beats the legendary Suzuki Hayabusa engine. The resonating feel of pure power evokes an attitude of bold authority from both machine and rider. Through countless engineering refinements of the original design, the Hayabusa spirit has endured. Its incomparable performance delivers a fun and sporty ride at any speed, setting the bar high for rivals and defining the “Ultimate Sport Bike.” The radically original yet timeless styling also reflects the spirit of the person who owns a Hayabusa. 1999
Pricing Information The cultural scene in Cuba is rich and we will have many opportunities to experience this richness. We will exchange cultural ideas at the homes of artists (some of them internationally known) see their work, visit various craft fairs, experience the wonderful national art museum in Havana, as well as the museum of the Revolution and other historic sites and enjoy the Latin music and dance of Cuba. Our time in Havana will include walks through Old Havana, a UNESCO World Heritage Site and visits to other neighborhoods which display the incredibly diverse architectural and artistic glories of Cuba. Trip to Havana Includes: Flights Miami - Havana - Miami via US chartered flights ALL meals but three dinners in Paladars (private homes - approx. $50 pp, each), Airport Exit Tax: approx. 25 Cuban Convertible Pesos - to be paid in Cuban Convertible Pesos (approx. $30 dollars) and gratuities to the guide and driver. $5,800 per person based on double occupancy Single supplement: please add $700 About Parque Central Hotel Standing in the heart of Old Havana, facing Central Park and just a few minutes from the Capitol and several major tourist attractions. This historic site was considered the heart of Havana in the 1950s and 1960s as it served as a venue for well-known Cuban orchestras and musicians such as Aragon and Enrique Jorrín. Over time the original hotel structure deteriorated and in 1999 the reinvented Hotel Parque Central opened its doors. This elegant and magnificent space located in the historic center of Havana is a harmonious mixture of past and future.
The most comprehensive on-line source for Bingo merchandise and equipment. Launched in 1999, the BingoShop's inventory and customer base has continued to grow as the Bingo Industry has evolved with the gaming marketplace.
INDEX OF RECIPES ARMED FORCES RECIPE SERVICE UNITED STATES ARMY TM 10-412 UNITED STATES NAVY NAVSUP Publication 7 UNITED STATES AIR FORCE AFM 146-12, Volume 2 UNITED STATES MARINE CORPS MCO P10110.4G 2003 INDEX Supercedes TM 10-412/NAVSUP Pub 7/AFM 146-12, Vol II/MCO P10110.43E, May 1999 COG I Stock No. 0530-LP-011-3090 Instructions: 1) Click on the links below to view a Sections Index. 2) Click on a Recipe link to view a Recipe Card. 3) After viewing a Recipe Card, use your readers “Back” Navigation Button to return to the Index. 4) Use the “Bookmarks” Tab on the left to view a listing of “quick links” to Sections and Categories within this Index. RECIPE SECTIONS: Section A – General Information Section B – Appetizers Section C – Beverages Section D – Breads & Sweet Doughs Section E – Cereals & Pasta Products Section F – Cheese & Eggs Section G – Cakes Section G – Frostings Section H – Cookies Section I – Pastry & Pies Section J – Puddings & Other Desserts Section K – Desserts (Sauces & Toppings) Section L – Beef, Pork, & Lamb Section L – Fish Section L – Poultry Section M – Salads Section M – Dressings Section N – Sandwiches Section O – Dressings, Gravies, & Sauces Section P – Soups Section Q – Vegetables Meatless Entrée Alternatives...